BlackIceMX/IceCore PMOD pinout diagram

electrified 2019-07-06 14:15:07 UTC #1

Hi,

I was spending a lot of time cross referencing the schematic and the pin constraints, so made this diagram to make it a bit easier.

If you spot any mistakes or there is anything you'd like adding let me know.

Cheers,
Ed

lawrie 2019-07-06 14:29:56 UTC #2

Wonderful! Just what I wanted.

Folknology 2019-07-07 11:04:46 UTC #3

This is great work Ed I see you are using the original BlackEdge numbering, we should prob ad a BE[] pins array in the PCF file given that we converted it to Pmods, although the BE numbers are in the comments for each pin..Either that or have an alternate BlackEdge-IceCore.PCF file..

electrified 2019-07-07 16:27:52 UTC #4

Thanks. I mainly went with that numbering as it's what's on the schematics, so it's easy to refer back to that.

I'll see if I can add the PMOD numbers, I've generally been rolling a new constraints file for each project though rather than using generic names.

Folknology 2019-09-02 09:04:05 UTC #5

Hope you don't mind Ed I have copied your fantastic pinout diagram onto the BlackIceMx wiki for everyone to use.

hirosh 2021-01-23 22:27:59 UTC #6

Hi,

I have modified the pinout from icoboard to run with blackicemx. You are able to determine the port via an uart. You have only to put the wire into the port and you can see the port name on the screen.
Just make a cat /dev/ttyUSB0.

I have done a pull request for it: https://github.com/folknology/IceCore/pull/8/commits/235e45f7f04d4f5c206804f807cbe56abf5d4ffb